SYMBIOS LOGIC 53C875J DRIVERS FOR WINDOWS MAC

On some early PCI systems with the 53C chip on the motherboard, the interrupt pin on the chip is not connected. All forum topics Previous Topic Next Topic. You can still use the tar command to add or extract files to or from the tape in the drive. I’ve found that some operating systems are not fussy at all and others are very fussy on the Proliant Contact Email us Tell us what you think. These configurations are not supported.

Uploader: Yozshugor
Date Added: 11 February 2010
File Size: 50.28 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 11279
Price: Free* [*Free Regsitration Required]

On some Pentium motherboards Intel NX symbios logic 53c875j using P90 or slower processors, ncrs hangs and this message is displayed on the console: You can still use the tar command to add or extract files to or from the tape in the drive. It might not be a driver problem though, the is not LVD!

I’ve found that some operating systems are not fussy at all and others are very symbios logic 53c875j on the Proliant Thanks John, I’ll give the other driver a try tonight. In case it might be a problem with the tape drivers, here’s symbios logic 53c875j info as listed in device mangler: If the DOS partition isn’t created, the system won’t reboot after Solaris installation.

In these instances, the system recovers and the tape drive remains usable. These configurations are not supported. Create at least a 1-cylinder DOS partition starting at cylinder 0. You can suppress these warnings by disabling tagged queuing in the ncrs.

All forum topics Previous Symbios logic 53c875j Next Topic. Proliant running Windows Server yes, it’s true – 2x PII and I’m getting strange behavior media incorrectly identified from both tape drives, one symbios logic 53c875j to each of the two Symbios Logic 53C controllers on the system.

Will it perhaps fix the issues with the tape drives? On some early PCI systems with the 53C chip on the motherboard, 35c875j interrupt pin on the chip is not connected. Is this the right one to use? Hi, I have an old?

CONFIG_SCSI_SYM53C8XX_2: SYM53C8XX Version 2 SCSI support

The opinions expressed above are the personal opinions of symbios logic 53c875j authors, not of Hewlett Symnios Enterprise. On some Pentium motherboards Intel NX chipset using P90 or slower processors, ncrs hangs and this message is displayed on the console:.

Hewlett Packard Enterprise International. I have also use the generic windows scsi driver too and been able to get it to work sometimes with symbios logic 53c875j devices. Hi Jim, Termination is important so make sure it’s good.

So there must be a termination problem I suppose, though I have symbios logic 53c875j idea how to fix it Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type. Do not attempt to connect wide targets to the narrow connector of the cards listed as supporting narrow disks.

Installation: Symbios SCSI

See the ncrs 7D man page. Do you symbios logic 53c875j help with your HP product? The ncrs symbios logic 53c875j supports at least Revision 4 of the 53C chipset. Such a system cannot be used with Solaris software. Previous revisions were pre-release versions of the chip, so 53c8775j might still be a few in circulation. Contact Email us Tell us what you think.

By using this site, you accept the Terms of Use and Rules of Participation. Upgrading the motherboard BIOS, the add-in card, or both may prevent these conflicts. I’ve even went so far as to dismantle the server and the tape drives a clean them of dust that was a bunch, yuk.